This tutorial is about How to Setup a Cisco Switch. Recently I updated this tutorial and will try my best so that you understand this guide. I hope you guys like this blog, How to Setup a Cisco Switch. If your answer is yes after reading the article, please share this article with your friends and family to support us.
Check How to Setup a Cisco Switch
The initial step is to verify what hardware you are using before you begin. Assuming you are using a Cisco switch, you really want to know what screen you have. Also, you need to actually analyze the actual health of the device and confirm that the links are not generally damaged. You can turn on the switch to make sure there is no damage to the lights / indicators.
Now that you have ensured that the device is ready to go, you are ready to start configuring. In this help, we will perform a Cisco switch configuration via the command line interface (CLI) with the open source PuTTY SSH / Telnet client (although you can use another device assuming you want to). If, under any circumstance, clay is not a possibility for your setting, you can obtain comparable results with a PuTTY elective.
Steps to configure the Cisco switch using CLI
Use an external emulator such as Telnet or PuTTY to log into the switch.
- The initial command prompt “Change>” appears on the screen.
- Type “enable” next to it and hit “Enter.”
- This will take you to “EXEC” mode, also known as global configuration mode.
- Go to configuration mode using the configuration terminal.
- Enter the configuration commands one per line.
Switch # configure terminal Switch (config) #
Provide a host name for the switch to work in a particular network environment.
Switch (config) # hostname switchSwitch (config) #
Set an admin password (enable secret password)
Switch (config) #enable secret somestrongpass
Configure the default gateway
Switch (config) # ip default-gateway IP-address Switch # show ip route
Configure static route
Switch (config) # ip route dest_IP_address mask Switch # show running-config
Configure the interface description
Switch (config) #interface fastethernet 0/1 Switch (config-if) #description Development VLAN
Clear MAC address table
change # clear mac address table
Set the duplex mode
Switch (config-if) # full duplex
Exit interface configuration mode
Switch (config-if) #exitSwitch (config) #
Exit setup mode
Switch (config) # exitSwitch #
Copy the running configuration to the startup configuration using the following command
Change # write memory build configuration … Change#
Final remarks: How to Setup a Cisco Switch
I hope you understand this article, How to Setup a Cisco Switch. If your answer is no, you can ask anything via the contact forum section related to this article. And if your answer is yes, please share this article with your friends and family to give us your support.
